Cylinder Block and Internal Components/Remove, Inspect and Install Tappets INSPECT AUTOMATIC COMPRESSION RELEASE (A.C.R.) 1. Remove camshaft. (See this group.) 2. Inspect automatic compression release (A.C.R.) for damage. M80416 -UN-25APR91 3. Inspect spring (C). Replace if worn or damaged. 4. Move weight(s) (B) by hand to check for proper operation. 5. Check that top of tab (A) sits slightly above cam lobe when weights are released. Tab should drop below cam when weights are operated. 6. Replace A.C.R. if it does not operate properly. 7. Install camshaft.
MX,4520A1,A6 -19-21OCT92 CTM5 (20OCT92) 45-20-4 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=385 REMOVE, INSPECT AND INSTALL TAPPETS 1. Remove camshaft. (See this group.) NOTE: Mark tappets so they can be installed in their original bores during assembly. -UN-25APR91 2. Remove tappets (A). 3. Inspect tappets for wear or damage. Replace if necessary. M80417 4. Apply clean engine oil to tappets and bores. 5. Install tappets in original bores. 6. Install camshaft. MX,4520A1,A7 -19-21OCT92 45 20 4