John Deere K Series Air-Cooled Engines — INSPECT CYLINDER BLOCK

Cylinder Block and Internal Components/Inspect INSPECT CYLINDER BLOCK 1. Remove crankshaft. 2. Clean and check block for cracks. 3. Cracks not visible to the eye may be detected by coating the suspected area with a mixture of 25 percent kerosene and 75 percent light engine oil. 4. Wipe area dry and immediately apply coating of zinc oxide dissolved in wood alcohol. If crack is present, coating becomes discolored at the defective area. Replace block if any cracks are found. MX,4520A1,A30 -19-21OCT92 CTM5 (20OCT92) 45-20-19 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=400 NOTE: A bare block is available for service. 5.

Measure cylinder bore parallel with crankshaft and right angles to crankshaft at top and bottom of ring travel. -UN-23FEB89 6. If cylinder bore exceeds wear limit, replace cylinder block or rebore cylinder. (See this group.) NOTE: If cylinder is rebored, oversize piston and rings must be installed. M51745 7. Install crankshaft. CYLINDER BORE SPECIFICATIONS Standard . . . . . . . . . . . . . . . . . 77.98—78.00 mm (3.070—3.071 in) Wear Limit . . . . . . . . . . . . . . . . . . . . . . . . . . 78.07 mm (3.074 in.) Out-of-Round (Max) . . . . . . . . . . . . . . . . . . . . 0.056 mm (00022 in.) -UN-25APR91 M54799 MX,4520A1,A31 -19-21OCT92 45 20 19