Cylinder Block and Internal Components/Inspect CTM5 (20OCT92) 45-20-18 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=399 INSPECT OIL SEALS NOTE: Pack lithium base grease in new or used seals. 1. Remove flywheel. (See Group 10.) -UN-25APR91 2. Remove governor shaft. (See this group.) 3. Inspect oil seals (A, B and C). Replace if necessary. 4. Remove crankshaft. (See this group.) M80435 5. Remove worn or damaged seals with a screwdriver. Flywheel End 6. Install seals with lip to inside of engine using a bearing, bushing and seal driver set. Press in seal on flywheel end until flush with hub.
Press in seal on PTO end to specification, below -UN-25APR91 crankcase cover flange surface. Press in governor shaft seal to specification, below flange surface. M80436 7. Install crankshaft. PTO End 8. Install flywheel. 9. Install governor shaft. SEAL DEPTH SPECIFICATIONS PTO End . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 mm (0.158 in.) -UN-25APR91 Governor Shaft . . . . . . . . . . . . . . . . . . . . . . . . 1.42 mm (0.056 in.) M80437 Governor Shaft MX,4520A1,A29 -19-21OCT92 45 20 18