John Deere K Series Air-Cooled Engines — INSPECT AND REPLACE GOVERNOR SHAFT

Cylinder Block and Internal Components/Inspect and Replace INSPECT AND REPLACE GOVERNOR IMPORTANT: Removal damages governor. If not damaged, do not remove. 1. Remove crankcase cover. (See this group.) M51762 -UN-07SEP88 2. Inspect governor. If necessary to replace, remove with screwdriver. 3. If removed, press shaft (C) back into block until it protrudes 32.2—32.8 mm (1.267—1.291 in.). NOTE: Assemble sleeve and gear before installing assembly on shaft. 4. Install sleeve (A) onto governor gear (B). 5. Install governor assembly onto shaft. Push down on assembly until it snaps into place. 6. Install crankcase cover.

MX,4520A1,A40 -19-21OCT92 CTM5 (20OCT92) 45-20-24 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=405 INSPECT AND REPLACE GOVERNOR SHAFT NOTE: It is not necessary to remove governor shaft unless seal is leaking or shaft is damaged. -UN-25APR91 1. Remove crankcase cover. (See this group.) 2. Inspect shaft (D). Replace if damaged. 3. To replace shaft, loosen nut (C) on lever (B). M80444 4. Remove retaining pin (A), governor shaft and washers (E). A—Retaining Pin 5. Install washers, shaft and retaining pin. Tighten nut. B—Governor Lever C—Nut D—Governor Shaft E—Washers MX,4520A1,A41 -19-21OCT92 45 20 24