John Deere K Series Air-Cooled Engines — INSPECT STARTER

Starting Systems/Electric Starter CTM5 (20OCT92) 45-30-6 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=413 INSPECT STARTER -UN-19JUN90 M53943 A—Front Cover E—Pinion Stopper Half I—Armature M—Brush B—Solenoid F—Retaining Clip J—End Cover N—Brush Holder C—Shift Lever G—Pinion Stopper Half K—Insulator O—Body D—Washer H—Pinion L—Brush Spring 1. Mark body and covers for correct alignment during 5. Test starter armature and brushes. (See this reassembly. group.) 2. Separate pinion stopper halves (E and G) to 6. Apply a thin coat of multipurpose grease to: remove retaining clip (F). —sliding surfaces of armature and solenoid shift lever. 3. Inspect parts for wear or damage.

—armature shaft spline. —points where shaft contacts cover. 4. Measure brushes. Replace brushes as a set if length of any one is less than 6 mm (0.240 in.). 7. Assemble starter. MX,4530A1,A8 -19-21OCT92 45 30 6