John Deere K Series Air-Cooled Engines — SERVICE BREATHER

Fuel and Air Systems/Service IMPORTANT: To remove float, use a long nosed pliers on end of pin. Do not strike opposite end of pin. Damage to pin holder may result. IMPORTANT: Rinse carburetor body in warm water to neutralize corrosive action of cleaner on aluminum. 3. Rinse carburetor with warm water and dry with compressed air. Do not use rags or paper to dry parts: lint may plug holes or passages. Do not clean holes or passages with small drill bits or wire. 1. Soak carburetor body and all parts, except gaskets, float and plastic rings, in carburetor cleaning solvent for 1/2 hour maximum. 4. Inspect all parts for wear or damage, replace as necessary. NOTE:

Main jet high altitude kits are available. 2. Spray all passages with a carburetor cleaning spray to verify that all internal passages are open. Float is plastic. The float cannot be adjusted. Replace if necessary. MX,3005A1,A4 -19-21OCT92 SERVICE BREATHER 1. Remove flywheel. (See Group 10.) 2. Remove breather cover and valve. M50144 -UN-31AUG88 MX,5005A1,A5 -19-21OCT92 CTM5 (20OCT92) 50-05-5 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=424 3. Inspect breather valve (A), valve seating surface (B) and rubber gasket (C) for wear or damage. Replace parts if necessary. -UN-29AUG88 M38042 MX,5005A1,A6 -19-21OCT92 50 05 5