Cylinder Block, Valves and Internal Components/Remove and Install Valves and Springs CTM5 (20OCT92) 50-20-3 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=434 REMOVE AND INSTALL VALVES AND SPRINGS 1. Remove carburetor. (See Group 05.) 2. Remove cylinder head. (See Group 15.) -UN-29AUG88 3. Remove tappet chamber cover and gasket. IMPORTANT: Mark and keep springs and valves together. M38082 4. Compress valve spring (A) with a spring compressor (B) and move spring retainer (C) so larger hole is around valve stem. 5. Remove compressor, valves, springs, retainers and exhaust valve rotator (D). -UN-19FEB91 NOTE: Exhaust valve spring is shorter than intake valve spring. 6.
Inspect and analyze valves. (See Section 100, Group 05.) M80204 7. Inspect springs, valve guides and seats. (See this group.) A—Valve Spring 8. Check valve-to-tappet clearance. (See this group.) B—Spring Compressor C—Spring Retainer 9. Check that drainback hole (E) is open. D—Valve Rotator E—Drainback Hole 10. Align valve springs, retainers and valve rotator in tappet chamber. 11. Coat valve stems with oil and install in cylinder block. 12. Compress each spring and position retainer so smaller hole is around valve stem. 13. Install tappet chamber cover and new gasket. 14. Install cylinder head. 15. Install carburetor. MX,5020A1,A2 -19-21OCT92 50 20 3