Fuel and Air Systems—FA130D/Disassemble, Clean, Inspect and Assemble Carburetor CTM5 (20OCT92) 20-05-3 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=36 DISASSEMBLE, CLEAN, INSPECT AND ASSEMBLE CARBURETOR—FA130D-AS16/AS19 IMPORTANT: Do not clean holes or passages with small drill bits or wire. 1. Soak carburetor body and all parts, except gaskets and plastic rings, in carburetor cleaning solvent for 1/2 hour maximum. 2. Spray all passages with a carburetor cleaning spray to verify that all internal passages are open. IMPORTANT: Rinse carburetor body in warm water to neutralize corrosive action of cleaner on aluminum. 3.
Rinse carburetor with warm water and dry with compressed air. Do not use rags or paper to dry parts: lint may plug holes or passages. 4. Inspect all parts for wear or damage, replace as necessary. A—Throttle Shaft B—Choke Shaft C—Pilot Screw D—Spring E—Bushing F—Spring G—Idle Screw H—Screw I—Gasket J—Choke Valve K—Spring -UN-07SEP88 L—Spring Cap M—Gasket N—Diaphragm O—Lower Housing P—Main Jet Q—Bushing M51767 R—Strainer S—Upper Housing MX,2005A1,A5 -19-21OCT92 20 05 3