John Deere K Series Air-Cooled Engines — DISASSEMBLE, CLEAN, INSPECT AND ASSEMBLE CARBURETOR—FA130D-AN00

Fuel and Air Systems—FA130D/Disassemble, Clean, Inspect and Assemble Carburetor CTM5 (20OCT92) 20-05-4 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=37 DISASSEMBLE, CLEAN, INSPECT AND ASSEMBLE CARBURETOR—FA130D-AN00 IMPORTANT: To remove float, use a long nosed pliers on end of pin (M). Do not strike opposite end of pin. Damage to pin holder may result. Do not clean holes or passages with small drill bits or wire. 1. Soak carburetor body and all parts, except gaskets and plastic rings, in carburetor cleaning solvent for 1/2 hour maximum. 2. Spray all passages with a carburetor cleaning spray to verify that all internal passages are open. IMPORTANT:

Rinse carburetor body in warm water to neutralize corrosive action of cleaner on aluminum. 3. Rinse carburetor with warm water and dry with compressed air. Do not use rags or paper to dry parts: lint may plug holes or passages. 4. Inspect all parts for wear or damage, replace as necessary. A—Throttle Plate N—Washer B—Throttle Shaft O—Plug C—Pilot Jet P—Drain Screw D—Choke Shaft Q—Spring E—Pilot Screw R—Float Chamber F—Idle Screw S—Float -UN-19MAR91 G—Spring (2 used) T—Bleed Pipe H—Carburetor Body U—Main Nozzle I—Spring V—Washer J—Ball W—Main Jet K—Choke Plate X—Needle Valve L—Gasket Y—Washer M80236 M—Float Pin MX,2005A1,A6 -19-21OCT92 20 05 4