Cylinder Block, Valves and Internal Components/Reciprocating Balancer INSPECT BALANCER ASSEMBLY 1. Clean and inspect all parts for wear or damage. Replace parts, if necessary. 2. Measure crankshaft journals (A). Replace crankshaft if diameter is less than specifications. 3. Measure inside diameter of bearings (B). Replace link rod if small end is greater than specifications. Replace bushing if large end is greater than specifications. (See this group.) 4. Measure inside diameter of support shaft bearing (C). If bearing is greater than specifications, replace bushing. (See this group.) 5. Measure support shaft diameter (D). Replace shaft if diameter is less than specification.
M51760 -UN-07SEP88 6. Inspect wrist pins (E) for any damage. If necessary, replace weight. DIAMETER SPECIFICATIONS Link Rod Journal O.D. (MIN) . . . . . . . . . . . . . . 53.95 mm (2.124 in.) Link Rod Small End I.D. (MAX) . . . . . . . . . . . . 12.06 mm (0.475 in.) Link Rod Large End I.D. (MAX) . . . . . . . . . . . . 54.12 mm (2.132 in.) Support Shaft O.D. (MIN) . . . . . . . . . . . . . . . . 25.93 mm (1.021 in.) Support Shaft Bearing I.D. (MAX) . . . . . . . . . .
26.10 mm (1.027 in.) A—Link Rod Journals B—Link Rod Bearings C—Shaft Bearing D—Support Shaft E—Wrist Pins MX,5020A1,A17 -19-21OCT92 CTM5 (20OCT92) 50-20-12 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=443 REPLACE BALANCER BUSHINGS NOTE: Remove bushings using a bearing, bushing and seal driver set and a press. Remove link rod bushings with oil groove side -UN-31AUG88 facing up. 1. Remove bushings. 2. Install link rod bushings with seam (A) at a 90˚ angle M51681 to centerline (C). 3. Install bushing below surface to specifications. A—Bushing Seam SPECIFICATIONS B—Oil Grooves C—Link Rod Centerline Bushing Depth (D) . . . . . . . . . . . . . . . . . . . . .
0.50 mm (0.020 in.) D—Measurement MX,5020A1,A18 -19-21OCT92 50 20 12