Cylinder Block, Valves and Internal Components/Inspect INSPECT OIL SEALS NOTE: Pack lithium base grease in new or used seals. 1. Remove flywheel. (See Group 10.) 2. Inspect oil seals (A and B) at flywheel end and PTO end for wear or damage. Replace if necessary. M38104 -UN-29AUG88 M50071 -UN-31AUG88 3. Remove crankshaft. (See this group.) 4. Remove worn or damaged seals with a screwdriver. Flywheel Side 5. Install seals with lip to inside of engine using a bearing, bushing and seal driver set. Press in seal on flywheel side until flush with hub. Press in seal on PTO side to specification, below crankcase cover flange surface. 6. Install crankshaft. 7. Install flywheel.
SPECIFICATIONS Seal Depth . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 mm (0.200 in.) PTO Side MX,5020A1,A38 -19-21OCT92 50 20 22 CTM5 (20OCT92) 50-20-22 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=453