Cylinder Block, Valves and Internal Components/Cylinder Block REPLACE CYLINDER HEAD/BLOCK STUDS 1. Remove cylinder head. (See Group 15.) 2. Inspect studs for cracks or wear. Replace if necessary. M80230 -UN-19FEB91 3. Install two nuts on stud and tighten together. Remove stud. 4. Put thread lock and sealer (medium strength) on threads of stud and install in block. Tighten to specification. 5. Install cylinder head. TORQUE SPECIFICATIONS Cylinder Head-to-Block Studs . . . . . . . . . . . . . . . . 36 N·m (27 lb-ft) MX,5020A1,A38A -19-21OCT92 CTM5 (20OCT92) 50-20-23 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=454 INSPECT CYLINDER BLOCK 1. Remove crankshaft. (See this group.) 2.
Clean and check block for cracks. 3. Cracks not visible to the eye may be detected by coating the suspected area with a mixture of 25 percent kerosene and 75 percent light engine oil. 4. Wipe area dry and immediately apply coating of zinc oxide dissolved in wood alcohol. If crack is present, coating becomes discolored at the defective area. Replace block if any cracks are found. MX,5020A1,A39 -19-21OCT92 50 20 23