John Deere K Series Air-Cooled Engines — ANALYZE VALVES

Group 05 Valves INSPECT VALVES 1. Remove carbon from valve head, face and stem with a power-operated wire brush. Be sure carbon is removed, not merely burnished. 2. Check valve faces, heads and stems for defects. M38087 -UN-21AUG92 3. Replace warped valves (A) or valves with less than 0.6 mm (0.02 in.) margin (B). Valve stem ends (C) should be ground square before you check valve-to-tappet clearance. MX,10005A1,A1 -19-21OCT92 4. Inspect valve stem for bend using V-blocks and a dial indicator. Turn valve slowly and read variation on indicator. Replace if variation is greater than specification. BEND SPECIFICATION (MAX) M51753 -UN-07SEP88 Valve Stem . . . . . . . . . . . . . . . . . . . . . .

. . . . 0.03 mm (0.001 in.) M98,2015A,A18 -19-21OCT92 CTM5 (20OCT92) 100-05-1 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=474 ANALYZE VALVES Lead deposits on the intake valve are caused by exhaust gas leakage past the valve. This indicates that the valve is not seating properly. -UN-06SEP88 IMPORTANT: Do not grind the exhaust valve or valve life will be shortened. Grind intake valve and reface the seat to correct this condition. M29934 NOTE: Be sure to reset valve-to-tappet clearance after grinding valves. MX,10005A1,A2 -19-21OCT92 100 05 1