John Deere K Series Air-Cooled Engines — ANALYZE PISTON RING WEAR

Group 10 Piston, Piston Rings, Crankshaft and Connecting Rod ANALYZE PISTON RING WEAR Rings of the wrong size or rings having improper end gap will not conform to the shape of the cylinder. This results in high oil consumption and excessive blow-by. Ring end gaps should be staggered on the piston during installation. End gaps in alignment can also cause oil consumption and blow-by. M29943 -UN-06SEP88 Light scuffing or scoring (A) of both rings and piston occurs when unusually high friction and combustion temperatures approach the melting point of the piston material. When this condition exists, it is due to one or more of the following probable causes: 1.

Dirty cooling shroud and cylinder head. 2. Lack of cylinder lubrication. 3. Improper combustion. 4. Wrong bearing or piston clearance. 5. Too much oil in crankcase causing fluid friction. MX10010A1,A1 -19-21OCT92 The engine operating at abnormally high temperatures may cause varnish, lacquer or carbon deposits (A) to form in the piston grooves making the rings stick. When this happens, excessive oil consumption and blow-by will occur. Engine overheating and ring sticking is usually caused by one or more of the following: 1. Overloading. 2. Incorrect ignition timing. 3. Lean fuel mixture. 4. Dirty cooling fins. 5. Incorrect oil. 6. Low oil supply. 7. Stale fuel.

M29944 -UN-06SEP88 MX,2420G,69 -19-21OCT92 100 10 1 CTM5 (20OCT92) 100-10-1 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=478