Blower Housing and Flywheel/Flywheel Screen Adjustment FLYWHEEL SCREEN ADJUSTMENT Adjust gap (C) between the blades under screen (A) and blower housing (B) to specifications using spacers. FLYWHEEL SCREEN ADJUSTMENT M38037 -UN-29AUG88 Gap . . . . . . . . . . . . . . . . . . . . . . . . . . 1—3 mm (0.039—0.118 in.) MX,2010A1,A3 -19-21OCT92 CTM5 (20OCT92) 20-10-2 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=55 REMOVE AND INSTALL BLOWER HOUSING—FA210D-AS19-01/AS17/BS17/CS17 1. Remove recoil starter. 2. Remove fuel pump, if equipped. (See Group 05.) -UN-11MAR91 3. Disconnect wiring lead (A), if equipped. 4. Remove nut and washer (B), starter cup/screen assembly (C), and spacer(s).
M80290 5. Remove blower housing (D). 6. Install blower housing. A—Wiring Lead B—Nut and Washer 7. Install spacer(s) and starter cup/screen assembly. C—Starter Cup/Screen Assembly D—Blower Housing 8. Adjust flywheel screen. (See this group.) NOTE: Install washer with concave side toward flywheel. 9. Install washer and nut. Tighten nut to 60 N·m (44 lb-ft). 10. Connect wiring lead, if equipped. 11. Install fuel pump, if equipped. 12. Install recoil starter. MX,2010A1,A2 -19-21OCT92 20 10 2