Cylinder Block, Valves and Internal Components/Remove, Inspect and Install Tappets REMOVE, INSPECT AND INSTALL TAPPETS 1. Remove camshaft. (See this group.) NOTE: Mark tappets so they can be installed in their original bores during assembly. M80254 -UN-11MAR91 2. Remove tappets (A). 3. Inspect tappets for wear or damage. Replace if necessary. 4. Apply clean engine oil to tappets and bores. 5. Install tappets in original bores. 6. Install camshaft. MX,2020A1,A13 -19-21OCT92 CTM5 (20OCT92) 20-20-8 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=69 INSPECT AUTOMATIC COMPRESSION RELEASE (A.C.R.)—FA210D-AS20 1. Remove camshaft. (See this group.) 2.
Inspect automatic compression release (A.C.R.) for -UN-09JAN91 damage. 3. Inspect spring (A). Replace if worn or damaged. 4. Move weight (B) by hand to check for proper M54493 operation. 5. Check that tab (C) sits slightly above cam lobe when weight is released. Tab should drop below cam when weight is operated. 6. Replace A.C.R. if it does not operate properly. 7. Install camshaft. MX,2020A1,A12 -19-21OCT92 20 20 8