Cylinder Block, Valves and Internal Components/Camshaft INSPECT CAMSHAFT PLAIN BEARINGS 1. Remove camshaft. (See this group.) 2. Measure camshaft bearings in cylinder block and crankcase cover. Replace block or cover if diameter is greater than specification. M80252 -UN-11MAR91 M80253 -UN-11MAR91 3. Install camshaft. SPECIFICATIONS (MAX) Cylinder Block Crankcase Cover Cylinder Block Bearing Bearing FA130D 12.04 mm 12.04 mm (0.474 in.) (0.474 in.) FA210D 13.05 mm 13.05 mm (0.514 in.) (0.514 in.) Crankcase Cover CTM5 (20OCT92) 20-20-7 K Series Air Cooled Engine MX,2020A1,A11 -19-21OCT92 AllTractorManuals.com 220596 PN=68 INSPECT CAMSHAFT Inspect camshaft for worn or broken teeth. NOTE:
Camshaft and tappets are a matched set. Replace both camshaft and tappets if necessary. -UN-11MAR91 Measure PTO side journal (A), flywheel side journal (B), and lobes (C). Replace camshaft and tappets if less than specifications. M80251 SPECIFICATIONS (MIN) PTO Side Flywheel Side Cam Lobes Journal Journal FA130D 11.94 mm 11.94 mm 23.25 mm (0.469 in.) (0.469 in.) (0.915 in.) FA210D 12.94 mm 12.94 mm Intake: (0.509 in.) (0.509 in.) 26.45 mm (1.041 in.) Exhaust: 26.35 mm (1.037 in.) MX,2020A1,A10 -19-21OCT92 20 20 7