John Deere K Series Air-Cooled Engines — CHECK PISTON RING END GAP

Cylinder Block, Valves and Internal Components/Piston Rings CHECK PISTON RING END GAP 1. Before installing rings on piston, check end gap in cylinder bore. 2. Install each ring squarely in bore approximately 25.4 mm (1.0 in.) down from top of cylinder. M80261 -UN-11MAR91 3. Check end gap. Replace ring if end gap is more than specifications. END GAP SPECIFICATIONS Minimum End Gap . . . . . . . . . . . . . . . . . . . . . 0.18 mm (0.007 in.) Maximum End Gap . . . . . . . . . . . . . . . . . . . . . 1.00 mm (0.039 in.) MX,2020A1,A23 -19-21OCT92 CTM5 (20OCT92) 20-20-14 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=75 REMOVE AND INSTALL PISTON RINGS 1.

Remove piston rings with a piston ring expander. 2. Inspect piston. Clean piston ring grooves. (See this group.) -UN-06APR91 3. Check piston ring end gap. (See this group.) 4. Install top ring (A), second ring (B) and oil ring (C) with R or NPR mark facing up. Rings should turn freely M80234 in grooves. FA130D -UN-19MAR91 M80260 FA210D MX,2020A1,A22 -19-21OCT92 20 20 14