John Deere K Series Air-Cooled Engines — REMOVE, INSPECT AND INSTALL CRANKSHAFT

Cylinder Block, Valves and Internal Components/Crankshaft CTM5 (20OCT92) 20-20-15 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=76 REMOVE, INSPECT AND INSTALL CRANKSHAFT 1. Remove piston and connecting rod. (See this group.) 2. Remove crankshaft. -UN-11MAR91 IMPORTANT: A bent crankshaft must be replaced; it cannot be straightened. 3. Check crankshaft alignment (T.I.R.). (See this group.) M80262 4. Clean and inspect crankshaft. Replace if parts are FA130D scratched or damaged. 5. Analyze crankshaft and connecting rod wear. (See Section 100, Group 10.) 6. Measure crankshaft main bearing journals and -UN-11MAR91 connecting rod journal.

Replace crankshaft if measurements are less than specifications. 7. Cover keyway on flywheel end of crankshaft with tape to prevent seal damage when installing crankshaft. M80295 8. Apply clean engine oil to crankshaft bearings and FA210D journal. 9. Pack lithium based grease in oil seals. 10. Install crankshaft. 11. Install piston and connecting rod. JOURNAL SPECIFICATIONS (MIN) Main Bearing Journal Connecting PTO Side Flywheel Rod Journal Side FA130D — 21.97 mm 23.95 mm (0.865 in.) (0.943 in.) FA210D — 24.96 mm 26.95 mm (0.983 in.) (1.061 in.) MX,2020A1,A24 -19-21OCT92 20 20 15