91 Adjusting the standard set burner time 1. The heater must not be running. 2. Press and hold button (E) until the set operating time flashes. 3. Release button (E). 4. Set the desired standard operating time using the buttons (E) and (F) (from 10 - 120 minutes). When the set operating time disappears, it has been stored. Activation with vehicle contact on 1. Briefly press button (D). The display (A) will show the burner symbol with the time and day. The heating is activated; the auxiliary heater indicator in the centre console will light up. 2. The desired temperature can be set using rotary switch (G). The setting range lies between 10 | C and 30 | C. 3.
The heating remains in operation as long as the vehicle contact is on. 4. After turning off the vehicle contact, the heating remains operational for 15 minutes. This time can be reduced with button (E) to a minimum of 1 minute and increased with button (F) to a maximum of 120 minutes. 5. The heater fan remains in operation for approximately 3 minutes to cool the heater. Setting the time/date 1. Press and hold button (B) until the display starts flashing (after approx. 3 sec.). 2. Set the time with the buttons (E) and (F). Once the time has stopped flashing, it has been stored. 3. The day will start flashing. 2.
The heater fan remains in operation for approximately 3 minutes to cool the heater. Deactivation with vehicle contact on 1. Press button (D). The display and button illumination will be switched off. 2. The heater fan remains in operation for approximately 3 minutes to cool the heater. Cab, Instruments and Controls