Technical data ID no.
Name P02 26 Radial run-out, crankshaft P02 34 Permissible axial clearance of crankshaft P02 35 Thrust ring, thickness P02 36 Thrust ring, oversize P02 41 Parallelism of the con rod with respect to the pis - ton bolt P02 42 Parallelism of the con rod with respect to the pis - ton bolt P02 43 Piston bolt liner, inside diameter P02 45 Small end bush clearance between piston pin and small end bush P02 52 Big end bearing shells, inside diameter P02 55 Big end bearing, bore in con rod P02 56 Theoretical clearance between the big end bearing / lifting journal P02 61 Piston pin, diameter P02 71 Piston, diameter, standard P02 72 Piston, diameter, standard P02 70 Piston Main bearing Big end bearing Piston bolt Con-rod Piston © 02/2010 OBJ_DOKU-21741-001.fm 5/18 ID no.
Name Information Series Value Unit P02 26 Radial run-out, crankshaft maximum permissible deviation TCD 2013 L4 2V 0,07 mm L6 0,10 mm Main bearing P02 34 Permissible axial clearance of crankshaft in installed state TCD 2013 2V 0,1 - 0,3 mm P02 35 Thrust ring, thickness Standard (upper and lower half) TCD 2013 2V 2,9+0,05 0 mm P02 36 Thrust ring, oversize 1.
Step = 0.2 mm TCD 2013 2V 3,1+0,05 0 mm Con-rod P02 41 Parallelism of the con rod with respect to the pis- ton bolt permissible deviation at a distance of 100 mm TCD 2013 2V 0,05 mm P02 42 Parallelism of the con rod with respect to the pis- ton bolt permissible deviation at a distance of 100 mm TCD 2013 2V 0,05 mm P02 43 Piston bolt liner, inside diameter installed, unmachined TCD 2013 2V 42+0,05 +0,04 mm P02 45 Small end bush clearance between piston pin and small end bush TCD 2013 2V 0,034 - 0,056 mm Big end bearing P02 52 Big end bearing shells, inside diameter installed TCD 2013 2V 72,5+0,02 0 mm P02 55 Big end bearing, bore in con rod H6 TCD 2013 2V 72,5 mm P02 56 Theoretical clearance between the big end bearing / lifting journal TCD 2013 2V 0,036 - 0,095 mm Piston bolt P02 61 Piston pin, diameter TCD 2013 2V 42 -0,006 mm Piston P02 70 Piston Identification of the installation position on the piston base P02 71 Piston, diameter, standard Measuring point 1 = height 12 mm TCD 2013 2V 107,700 mm P02 72 Piston, diameter, standard Measuring point 2 = height 64 mm TCD 2013 2V 107,800 mm