Deutz — Removing and installing the injector

Injector TCD 2013 2V W 19-01-01 Removing and installing the injector Standard tools: Assembly pliers 8024 Torx tool set 8189 User notes Special tools: Special wrench 110500 Lever tool 110620 Assembly case with assembly sleeves, guides and disassembly tool 110900 Extraction tool 120680 Slide hammer 150800 Plugs/caps 170160 Danger! Wait 30 seconds after switching off the engine before working on the fuel system. Attention! Ensure utmost cleanliness when working on the fuel system. Carefully clean the area around the affected parts. Blow damp areas dry with compressed air. Observe the safety regulations and natio - nal specifications for handling fuels.

Close all connections immediately after opening with new, clean plugs/caps. Do not remove plugs/caps until immedia - tely before assembling. Collect leaking operating fluids in suitable vessels and dispose of according to regu - lations. After all work on the fuel system, it must be bleeded - see the operation manual, chap - ter "6 Fuel system“. 6 Removing the injector The following work procedure describes the removal and installation of an injector. Proceed in the same way to remove further injectors. Danger! Wait 30 seconds after switching off the engine before working on the fuel system. With oil dipstick guide pulled up on the side of the rail: Pull out oil dipstick. Close opening.

© 43954-0 © 02/2010 OBJ_DOKU-21789-001.fm 1/10