Deutz — Check alignment of connection housing

Connection housing TCD 2013 2V W 52-01-02 Position (I) ●Set the dial gauge with probe pin to position (I) at a right angle to the connection housing. ●Apply the probe pin to the connection housing with pre-tension. 6 I © 47688-0 ●Adjust dial gauge to "0". © 47689-0 Position (II) ●Turn the crankshaft slowly to position (II). ●Read off measured value. ●Note measured value, dimension (a). Note the sign! II ●Note the measured value (a) with the appropriate sign on the measurement sheet. © 47690-0 © 02/2010 OBJ_DOKU-21820-001.fm 2/6