SECTION 3 SAFETY AND OPERATION Page 24 OPERATING THE AIR CONDITIONER EQUIPMENT ON CONTROL PANEL It is possible to use the air conditioner to good effect in dusty jobsites. The outside air is passed through the filter and is sent to the operator’s cab to increase the pressure inside the cab. In this way, dust is prevented from entering, so comfortable operating conditions are always maintained for the operator FAN SWITCH * This is used for controlling the air flow when cooling or heating. * It can control the air flow to three levels: LO (low), ME (medium) and HI (High) AIR CONDITIONER SWITCH * This is the switch for cooling. ON: Push the button to carry out dehumidification and cooling.
The blue lamp lights up to indi- cate that the cooling system is on. OFF: If the system is ON and the button is pressed again, the switch returns to its original posi- tion and the air conditioner is switched off. l Turn the air conditioner switch on after turning the fan switch on. AIR INTAKE SELECTOR LEVER . This switches the air intake port when cooling or heating. FRESH: Operate the lever to the right. Fresh air is taken in from outside in addition to the air inside the compartment. (This is used for ordinary cooling or heating, and when pressurizing the inside of the cab.) RECIRC: Operate the lever to the left. Only the air inside the compartment is used.
(This is mainly used for quick cooling or heating ) TEMPERATURE CONTROL LEVER This is used to control the temperature for cooling or heating. The farther the lever is moved to the left, the lower the temperature of the air blown out from the vent. The farther the lever is moved to the right, the higher the temperature of the air blown out from the vent. If the outside air is extremely dusty, set the fan switch to the H position. This will pressurize the cab and prevent the dust from entering.