SECTION 3 SAFETY AND OPERATION Page 26 HANDLING THE AIR CONDITIONER IN SEASON To use the air conditioner comfortably during its season, ask your distributor to check the air conditioner and add the refrigerant if necessary. * The standard cleaning cycle for the fresh air filter is EVERY 100 HOURS, but if II becomes clogged, it will be impossible to pressurize the inside of the cab, and in addition, it may cause failures, so check and clean the filter immediately.
* If a large amount of dirt or dust collects on the condenser, the cooling capacity drops, so check and clean when necessary, for details, see WHEN REQUIRED For details of cleaning, see PERIODIC MAINTENANCE HANDLING THE AIR CONDITIONER IN OFF-SEASONS To lubricate each part of the compressor during the off-seasons, operate the air conditioner for a few minutes two or three times a month OPERATING CAB HEATER EQUIPMENT ON CONTROL PANEL It is possible to use the cab heater to good effect in dusty jobsites The outside air is passed through the filter and is sent to the operator’s cab to increase the pressure inside the cab In this way, dust is prevented from entering, so comfortable operating conditions are always maintained for the operator.
FAN SWITCH * This controls the air flow when the car heater is used for heating. * There are 3 levels: LO (Low), ME (Medium) and HI (High) TEMPERATURE CONTROL LEVER * This is used to control the temperature for cooling or heating. * The farther the lever is moved to the right, the higher the temperature of the air blown out from the vent. AIR INTAKE SELECTOR LEVER - This switches the air intake port when heating. * FRESH: Operate the lever to the right Fresh air is taken in from outside in addition to the air inside the compartment. (This is used for ordinary heating, and when pressurizing the inside of the cab.) * RECIRC: operate the lever to the left.
I Only the air inside the compartment is used. (This is mainly used for quick heating )