OPERATION SECTION 1 Psge 27 RIGHT SIDE ARMREST FORWARD-BACKWARD ADJUSTMENT Loosen bolts (1) to move the arm-rest to the desired position, and tighten the bolts. ANGLE ADJUSTMENT Loosen bolts (2) to move the armrest to the desired angle and tighten the bolts, Fasten the belt and remove lt in the following manner. r 1. Adjust the seat so that the brake pedal can be depressed all the way with the operator’s back against the backrest. _ WAARNINGI Before fastening the seat heft, inspect the securing brackets and belt for abnormal conditions. SEAT BELT 2. After positioning the seat, instail the tether heft (1). With the seat unoccupied, tense the belt slightly across the seat and install.
WARNINGI Check that there are no kinks in the belt. 3. Sit in the seat. Hold buckle (2) and insert (3) into the buckle (2). Check that the belt has locked by puffing fit, 4. When removing the belt, raise the tip of the buckle lever to release it. * When leaving the operator’s seat, release the seat belt and hang it over the arm rest. * Fasten belt along your body without kinking it. Adjust the lengths of the belt on both the buckle and the insert sides so that the buckle is located at the mid-point of your body front. Adjust the belt length in the following manner.
ii) To lengthen, pull the belt while holding it at a right angle to buckle or insert i) To shorten the belt, pull the free end of the belt on either the buckle body or insert side. 5. When operating a machine equipped with ROPS, be sure to use the seat belt. * Inspect bolts and fittings on the chassis for tightness. Retighten any loose bolts to 2 to 3 kgm torque. * If the seat is scratched or frayed or if any of the fittings are broken or deformed from long service, replace the seat belt immediately.