OPERATION SAFETY LOCK USAGE When it is necessary to perform maintenance, repairs or travel on roads, it is important to be aware of the safety locks equipped with the machine. It is also important to know how to use these locks and when to use them. Failure to observe these precautions and use the equipped safety equipment may result in a serious accident or injury. the lifting cylinders. 4. Install the cylinder lock (1) in the position shown in illustration (A), keeping the safety pin boss against the lift cylinder gland nut. 5. Insert the safety pin (2) completely into the pre-drilled holes and lock the pin in place with the smaller pin provided. 6.
Slowly lower the front end loader unit until it makes contact with the cylinder lock. 7. Check to be sure the cylinder lock is secularly in place before proceeding with any procedures under the front end loader. 2-44 WB140-2N, WB150-2N Safety locks should be used when: • Performing any maintenance on the machine. • When traveling on roads. • When the machine will be unattended. FRONT END LOADER CYLINDER LOCK In illustration (A) the front end loader cylinder lock (1) must be used any time you will be performing maintenance on the machine with the front end loader raised. To use the cylinder lock: 1. In illustration (B) remove the cylinder lock assembly pin (2) holding on to the lock unit (1).
2. Using both hands lower the lock unit (1) down from it’s storage position and remove it from the lift arm. 3. Raise the front end loader unit completely in the air extending