Komatsu — CHECKING ENGINE OIL LEVEL

CHECKING COOLANT LEVEL MAINTENANCE Do not remove the radiator cap; the coolant must be checked with the engine cold, through the expansion tank. The coolant level can be checked in expansion tank (1) with the engine cold, coolant must be between the MIN. and MAX. lower marks. The check must be performed through the hole positioned on the right side of the engine hood and the coolant level must be above the MIN. lower mark. If the level is near the lower limit of the MIN. mark, fill the tank with coolant, and if the level decreases considerably and constantly, check the radiator, engine, and radiator body for leaks. Also check fluid level in the radiator.

See “CHECKING COOLANT LEVEL” on page 3-27. Expansion tank (1) can be reached after opening the engine hood. The upper MIN. and MAX. marks indicate the expansion level of the coolant at operating temperature. CHECKING ENGINE OIL LEVEL After the machine is stopped, the engine is very hot. Let the engine cool down before performing any check. Hot engines may cause burns. Dipstick ( 1 ) can be reached through opening in the right side of engine hood, which is protected by inspection cover (2). The check must be performed with cold engine and the machine located on level ground. Oil level can be checked on the graduated dipstick (1) and must be between MIN. and MAX. marks.

If the level is near the MIN. mark, top off with oil suitable for the ambient temperature, as prescribed in the lubricant chart. See “FUEL, COOLANT, AND LUBRICANTS” on page 3-7. If it is necessary to check the oil level during or soon after work, stop engine and wait for 15 minutes before checking. WB140-2N, WB150-2N 3-27