Komatsu — CHECKING HYDRAULIC SYSTEM OIL LEVEL

MAINTENANCE CHECKING HYDRAULIC SYSTEM OIL LEVEL The oil level in the hydraulic system must be checked with cold oil and the machine positioned on level ground and in lubricating position. (See fig.). If it is necessary to top off, stop engine and then elimi- nate the residual pressures present in the work equip- ment (move the controls more than once) and in the tank by slowly loosening filling cap (2). The oil level must be visible through gauge (1) positioned on the tank and must be filled between MIN. and MAX. marks. If level is near the MIN. mark, top off by adding the prescribed hydrau- lic oil, see “FUEL, COOLANT, AND LUBRICANTS” on page 3-7, through filler (2).

Reinstall the filler cap. Use a 24 mm hexagon wrench. When adding oil, do not exceed the MAX level. This would damage the hydraulic system and cause oil to flow out. If a constant or abnormal decrease of the oil level is observed, thoroughly check the hydraulic system, the pistons and pump for leaks. 3-28 WB140-2N, WB150-2N