Komatsu — MAINTENANCE AFTER THE FIRST 250 HOURS OF OPERATION

MAINTENANCE CHECKING FRONT AXLE OIL LEVELS DIFFERENTIAL This visual check serves to verify if the lubricant reaches hole (1). If necessary, top off using the prescribed oil. (See “FUEL, COOLANT, AND LUBRICANTS” on page 3-7). Level hole ( 1 ) must also be used as the filler hole (use a 17 mm wrench). PLANETARY Conduct this check with each reduction gear positioned with the plug on the horizontal axis. If necessary, move the machine slightly until the specific position for a precise check is reached. This visual check serves to verify if the lubricant reaches hole (2). If this does not occur, add the prescribed oil. (See “FUEL, COOLANT, AND LUBRICANTS” on page 3-7). (Use a 17 mm wrench).

CHECKING REAR AXLE OIL LEVELS DIFFERENTIAL This check is visual and serves to verify if the lubricant reaches hole (1); if necessary, top off using the prescribed oil. (See “FUEL, COOLANT, AND LUBRICANTS” on page 3-7). Level hole (1) must be used also as filling hole (use a 1/2” square wrench). PLANETARY The check must be carried out on each reduction gear positioned with plug on the horizontal axis. If necessary, move the machine slightly until reaching the specific posi- tion that is indispensable for a precise check. This check is visual and serves to verify that the lubricant reaches hole (2); if this does not occur, top off using the prescribed oil.

(See “FUEL, COOLANT, AND LUBRICANTS” on page 3-7). (Use a 1/2” square wrench). 3-38 WB140-2N, WB150-2N