Komatsu — MAINTENANCE AFTER THE FIRST 250 HOURS OF OPERATION

CHECKING HYDRAULIC TRANSMISSION OIL LEVEL MAINTENANCE Level must be checked with the engine running and transmission oil at operating temperature; be very care- ful, in order to avoid burns. If it is necessary to add oil, stop engine before opening the engine hood. Prevent possible injury from unex- pected machine movement. Never rely on directional control lever alone to keep machine from moving. It can unexpectedly roll or move under power, resulting in death or serious injury. Always engage park brake to hold the machine. Dipstick (1) can be reached through the opening on the right side of the engine hood, which is protected by inspection cover (2).

The level must be checked with the engine running at 800 - 1000 rpm and with the transmission oil at operating temperature. The oil must always reach the maximum level mark, or be very near it. To add oil, use the dipstick (1) filler tube and the prescribed oil. (See “FUEL, COOLANT, AND LUBRICANTS” on page 3-7). # After checking the oil level, close inspection cover (2) and lock it. CHECKING WHEEL LUG NUT TORQUE This check is used to verify that driving torque of the wheel lug nuts on the hubs are correct. The driving torque must be checked by means of a torque wrench (1) set according to the values indicated in paragraph See “SPECIFIC TIGHT- ENING TORQUES” on page 3-21.

(Use a 27 mm wrench for the front wheels). (Use a 32 mm wrench for the rear wheels). # Do not Increase the specified driving torque and keep it within the prescribed ranges. # When the driving torque must be checked, do not lubricate the thread. WB140-2N, WB150-2N 3-39