MAINTENANCE 8. Raise the front mat and remove cover (11), using a 13 mm wrench. 9. Loosen bleeder plug (12) located on the hydraulic pump, until no air bubbles can be observed in the oil that flows out (use a 3 mm setscrew wrench). Tighten bleeder plug (12) and reinstall cover (11). 10. Reinstall filler cap (3). Start engine and operate the machine mak- ing each piston move several times in order to bleed the system. Stop machine in the maintenance position, check oil level again and if necessary, add oil. Always use oil of the prescribed type, (See “FUEL, COOLANT, AND LUBRICANTS” on page 3-7). 11. Put back the upper platform (1) with relevant fastening screws (2).
# Do not start engine with an empty tank, since this would certainly damage the pump. 3-52 WB140-2N, WB150-2N