# Hydraulic oil of the machines equipped with demolition hammer deteriorates more rapidly than oil of the machines used for simple digging operations. # Perform oil changes as scheduled on the accompanying table. MAINTENANCE CHANGING COOLANT After the machine has been operated, coolant is very hot and under pressure and it may cause serious burns. Let the engine cool down until it reaches approximately 40- 45°C (104-113°F) before changing the coolant. Slowly loosen radiator cap, in order to release the resid- ual pressure. Oils, filters, coolant, and the battery are considered spe- cial waste and must be collected and disposed of according to all anti-pollution regulations in force.
The following operations refer to changing permanent coolants, if the coolant is water or water with antifreeze, which are used according to the season, it is necessary to flush the cooling system in order to elimi- nate any encrustation. (See “FLUSHING COOLING SYSTEM” on page 3-59). 1. Open engine hood. 2. Loosen and remove upper radiator cap (1). WB140-2N, WB150-2N 3-53