CHANGING THE BRAKING SYSTEM OIL MAINTENANCE Oil spilled on the floor may cause it to become slippery; immediately clean any dirty area. Oils, filters, coolant, and the battery are considered spe- cial waste and must be collected and disposed of according to all anti-pollution regulations in force. Before changing braking system oil, it is advisable to brake a few times in order to warm the oil up to raise viscosity to facilitate draining. Changing oil and bleeding the brake system must be done with the machine positioned on level ground with the parking brake set. To drain oil and bleed the system, proceeding as follows: 1.
Attach a small hose (for collection of the oil) to drain screws (1) and loosen them, using a 13 mm wrench. 2. Open the engine hood and remove cap (2) from tank (3). 3. Operate the tandem brake pedals (connected to each other) until oil in tank (3) runs out. 4. Fill tank (3) with new oil and keep pumping. Fill tank (3) more than once, until the used oil (about 0.8 liters {1.7 US pint}) has been completely purged, Bleed the residual air. (See “BLEEDING BRAKE SYSTEM” on page 3-58). For details on oil to be used, See “FUEL, COOLANT, AND LUBRICANTS” on page 3-7. CHECKING ALTERNATOR AND STARTER For any inspection and/or repair, contact your Komatsu Dealer.
If the engine is started frequently, have inspection done every 1000 hours of operation. WB140-2N, WB150-2N 3-55