CLEANING THE WATER SEPARATOR MAINTENANCE 1. Loosen screw (1) and drain the contained in the water separator, collect it in a container with suitable capacity. Use a 13 mm wrench. 2. Loosen central screw (2), remove bowl (3), and filter element (4). Use a 14 mm wrench. 3. Clean inside of the pan and filter with diesel oil or oil. 4. Reinstall filter (4), bowl (3), tighten screws (2) and (1), and bleed the fuel supply circuit proceeding as described in chapter See “CHANGING FUEL FILTER” on page 3-44. # If the filter element is excessively clogged or damaged, replace it. 5. Start the engine.
CHECKING AND ADJUSTING FRONT WHEEL TOE-IN This check must be done according to time intervals scheduled by the operator, since any abnormality regarding the wheel toe-in is due to impacts or vibrations, depending on type of surface which the machine works. Another reason for performing this check is to examine the front tires for excessive wear. The machine has been designed with a toe-in equal to 0 mm. Every adjustment must restore this value and must be carried out on tie rods (1) after loosening nuts (2) that lock them. (Use 27 and 19 mm wrenches). During this check and the relevant adjustment, it is advisable to also check conditions of ball joints (3).
If considerable slack is observed, immediately replace them. WB140-2N, WB150-2N 3-61