When the backhoe is in use, and the telescoping arm is needed, remove the pin (4) and insert it into the holding place (6) for the pin OPTIONAL ATTACHMENTS Remark Always keep the safety pin with the machine. Never use a substitute or damaged pin. If it is missing or damaged have it replaced immediately. 3. Fold the arm until slide guides (8) are perpendicular to the ground and positioned so that the extendable part is completely free and does not strain the guides. 4. Stop the engine. 5. Check the side which has the guide adjusting dowels (9) protruding the most. Only make adjustments on this side.
Remark If adjusting dowels (9) protrude the same amount on both sides, the step 6 adjustment can be done on either the right or left side. WB140-2N, WB150-2N 5-11 The telescopic arm requires two maintenance procedures: • Lubrication of joints (grease fittings). S“LUBRICATION DIA- GRAMS” on page 3-12. • Adjustment of slide guide (8) slack done occasionally, when in pace or vibrations are noticed during work . When leaving the operators compartment to adjust the guides, remove the ignition key and tag the steering wheel. Adjust the screws and guides one by one. Do not place tools in the space between the safety locks and arm. 1.
Position the machine on a flat firm surface and lower both- outriggers. 2. Raise the boom, completely fold the bucket and completely extend the telescopic arm (7).