Komatsu — CONTROL LEVER POSITIONS

OPERATION OPERATING THE FRONT END LOADER AND BACKHOE When preparing to operate the front end loader or backhoe it is important to be aware of your working conditions and hazards involved, always study the job carefully before starting any operations. Operate within the operating parameters specified in this manual. Never use this work equipment for something it was not intended, damage to the equipment or injury to the oper- ator may result. OPERATING THE FRONT END LOADER Before using front end loader (4) be sure front end loader lock (3) is unlocked. When operating the front end loader you must be seated in the operator’s seat with the seat belt fastened firmly around your waist.

Be sure both outriggers are up and locked. Be sure the backhoe unit is locked and pined. See “BACKHOE LOCKS” on page 2-46. Check your work area to be sure no personnel are near you. Sound your horn before beginning work operations. . When operating the front end loader: Always keep the bucket as close to the ground as possi- ble. Never raise or lower the bucket while traveling, always come to a complete stop when raising or lowering the loader bucket. Avoid lowering the bucket too quickly, damage to the lift arm cylinders may result. When traveling with a loaded bucket maintain a height of 50 cm (20 in) above the ground.

When loader operations are completed lower the loader bucket to the ground and set the loader lock Avoid sharp turns with a loaded bucket. When loading the bucket, never ram a load at high speeds and never overload the bucket. CONTROL LEVER POSITIONS Loader Bucket and Arm Operations When the control lever is moved forward or backward and at right and left angles the bucket and arm will move in the positions indicated in the illustration. N - Neutral position (no boom or bucket movement) A - Bucket curl back B - Arm lower C - Bucket dump D - Arm raise E - Arm in free float position F - Self leveling (return to dig) 2-34 WB140-2N, WB150-2N