Komatsu — ORGANIZING YOUR WORK AREA

OPERATION Dual Functional Bucket and Arm Positions When the lever is operated in the direction shown in the illustration a dual function of the bucket and arm can be achieved. N - Neutral position (no boom or bucket movement) A - Arm lowering - Bucket curling B - Arm lowering - Bucket dumping C - Arm raising - Bucket dumping D - Arm raising - Bucket curling Remark Do not use the “Arm In Free Float Position” when traveling forward, the bucket will dig in and raise the machine up. The float feature should only be used when traveling in reverse performing grading operations.

PERFORMING LOADING OPERATIONS Before performing loading operations the operator must become familiar with the loader controls and its positions. The opera- tor must also be familiar with all safety involved when performing these operations. Failure to do so may result in damage to the machine or injury to the operator. BUCKET POSITION INDICATOR The machine is equipped with an automatic (RETURN-TO-DIG) fea- ture which determines the horizontal position of the bucket in relation to the ground. This position is reached when sensor (2) no longer detects rod (1) position. For adjusting rod (1): See “ADJUSTING AUTOMATIC RETURN OF FRONT BUCKET TO THE DIGGING POSITION” on page 3-64.

ORGANIZING YOUR WORK AREA Before starting any loading operations it is important to be sure your work area is safe and clear of any obstacles or hazards that may hinder your operations, damage the equipment or cause an accident. Check the ground to be sure it is level and stable. Study the loading pattern you will be using. The illustration gives an example of a simple loading pattern used by most operators. Before starting your operations, sound the horn, and be sure all person- nel are at least 20 m (40 ft.) away from you and your work area. Remark When using the declutch button during loader operations always bring the machine to a full stop before chang- ing speed ranges.

WB140-2N, WB150-2N 2-35