Komatsu — CHANGING THE FRONT BUCKET

WORKING ON SLOPES WITH A LOADED BUCKET OPERATION Working on a slope can be dangerous if safety and some basic precau- tions are not observed. Below is a list of some basic precautions that should be followed: 1. Always check the work area for snow, land slips, gravel, loose ground and anything that may suddenly modify the work conditions and stability of the machine. 2. Shift the machine into a low gear range. Do not change gear ranges or press any feature buttons when traveling up or down slopes. 3. When traveling up the slope, the front loader bucket must always be directed toward the top of the incline. 4.

When traveling down a slope with the bucket loaded, travel with the loaded bucket facing the top of the incline backing the machine down the incline. 5. Always keep the bucket at least 50 cm (20 in) above the ground. Never raise the bucket when traveling on a slope. 6. Never turn on a slope or travel at an angle on the slope. 7. Travel up or down the slope at a slow controllable speed. Remark If the machine should start to tip with the bucket loaded, lower the bucket and load on to the ground immedi- ately and quickly to help stabilize the machine and lower the center of gravity. CHANGING THE FRONT BUCKET When changing front loader buckets always ware gloves and eye protec- tion.

To change the front bucket: Position the bucket and machine on level ground. Remove the bolts (1) and coupling pins (2). Exchange the bucket (3), taking care to completely clean the pins and bushings before installing them. Reinstall the bolts and tighten them in place. Lubricate all pin locations. Never use your fingers or hands to line up the pin or bolt holes. If hole alignment is not correct, use a steel drift to line up parts. WB140-2N, WB150-2N 2-37