OPERATION OPERATING THE BACKHOE Before performing any backhoe operations the operator must become familiar with the backhoe controls and their positions. The operator must also be familiar with all safety involved when performing these operations. Failure to do so may result in damage to the machine or injury to the operator. Remark Remember the power in the backhoe unit is the breakout fea- ture when excavating or lifting. Do not use the backhoe unit to pick up, reposition or swing the machine to the left or right. Doing so will damage the swing cylinders or possibly tip the machine over.
POSITIONING THE MACHINE To start excavating operations position the machine in a safe and clear location. Be sure there is enough room to swing or extend the boom. To start operations: 1. Rotate the seat around to the backhoe operating position and lock the seat in place. See “SEAT AND SEAT BELT” on page 2-22. 2. Remove outrigger locks and backhoe lock pin (3). Retract the back- hoe locking (2) mechanism. See “SAFETY LOCK USAGE” on page 2-44. 3. Be sure your seat belt is fastened around your waist in a snug posi- tion. 4. Unlock the backhoe controls. 5. Be sure the machine directional control is set in a neutral position. 6.
Lower both outriggers (18 and 19) at the same time lifting the machine evenly and squarely. Be sure both outriggers are com- pletely extended together. Never operate the backhoe without low- ering the outriggers and do not lower the outriggers one at a time. Remark When retracting the outriggers, bring both outriggers up slowly and at the same time, lowering the machine evenly and squarely back down. 2-38 WB140-2N, WB150-2N