UNDERCARRIAGE / Track Assemble Special Tool (ST 1532) When Removing and Installing Master Pin The procedures (steps 5 to 11) are for assembly of special tool (ST 1532) when removing and installing master pin. If special tool (ST 1532) when removing and installing master pin has already been assembled, these procedures are unnecessary. IMPORTANT: Insert screws (9) (2 used) into the screw hole on hydraulic cylinder (8) completely. If screws (9) (2 used) are not inserted completely, screw (9) may be removed from hydraulic cylinder (8) when removing and installing master pin (3). 5. Install screws (9) (2 used) to hydraulic cylinder (8). IMPORTANT:
If lengths (A) of nut (10) at both sides are different, screw (9) may be deformed when removing and installing master pin (3). Install nuts (10) (2 used) to the position, same length (A) away from hydraulic cylinder (8). 6. Install nuts (10) (2 used) to screws (9) (2 used), where same length (A) away from hydraulic cylinder (8). 11. Install the hoses (2 used) of electric pump (ST 1531) to hydraulic cylinder (8). 10 9 8 A W1J7-03-07-005 CAUTION: Frame (11) weight: 74 kg (163 lb) 7. Insert frame (11) into the position for nut (10) in screws (9) (2 used) and tighten with nut (16). 8. Install extension (15) to hydraulic cylinder (8). NOTE: Extension (15) consists of three types.
The length for each is different. When the stroke of hydraulic cylinder (8) is insufficient during removal / installation work, add extension (15) in order to extend the stroke. 9. Install pilot (17) and pusher (12) to extension (15). 10. Install adapter (14) to frame (11) with handling screw (13). W3-7-5