UNDERCARRIAGE / Track CAUTION: Special tool (ST 1532) when removing and installing master pin weight: 150 kg (330 lb) 9. Attach a nylon sling to screws (9) (2 used) in special tool (ST 1532) when removing and installing master pin and hoist special tool. Move special tool (ST 1532) when removing and installing master pin to the mounting position for master pin (3). Adjust length of the nylon sling and align the master pin (3) mounting hole with adapter (14) hole and of position C in master pin (3) in special tool (ST 1532) when removing and installing master pin. IMPORTANT: Align the centers of adapter (14) and master pin (3) with that of master pin (3) mounting hole.
If the centers are not aligned and master pin (3) is installed, special tool (ST 1532) when removing and installing master pin may be deformed or damaged. 10. Align position A of guide pin (19) with the hole center of adapter (14) in special tool (ST 1532) when removing and installing master pin. Adjust hydraulic cylinder (8) and push master pin (3) to position B of guide pin (19). Check for the installation conditions of guide pin (19) and special tool (ST 1532) when removing and installing master pin. 11. Extend hydraulic cylinder (8) and insert master pin (3) until guide pin (19) is pushed out from the master pin mounting hole on track link (6).
ST 1532 W1J7-03-07-003 6 W1J7-03-07-006 NOTE: When the stroke of hydraulic cylinder (8) is insufficient, retract hydraulic cylinder (8) once. Add extension (15) between extension (15) and pilot (17) in order to extend the stroke. When extensions (15) (3 used) are added and the stroke of hydraulic cylinder (8) is insufficient, move the positions to install nuts (10, 16) (2 used for each) to the hydraulic cylinder (8) side. W1J7-03-07-005 W3-7-10 Nylon Sling 9 Nylon Sling 19 C 14 19 1 C B 3 1 16 10 9 8 17 15 (Inside) 10 9 17 15 (In 17 (In side)