hitachi — REMOVE AND INSTALL FRONT ATTACHMENT

FRONT ATTACHMENT / Front Attachment REMOVE AND INSTALL FRONT ATTACHMENT Removal 1. Park the machine on a solid, level surface. Fully retract the bucket and arm cylinders and lower the front attachment onto the ground. 2. Remove the connector in boom light between cab and main frame. 3. Remove lubrication hose (2) from the rod side of boom cylinder (1). (2 places on both right and left) W1J1-04-01-001 2 : 19 mm 4. Remove bolts (5) (4 used). Remove washer (3) and stopper (4). (2 places on both right and left) 1 : 30 mm W105-04-01-002 1 CAUTION: Boom cylinder weight: 430 kg (950 lb) CAUTION: Metal fragments may fly off when a hammer is used.

Wear necessary protection, such as goggles, hard hats, etc in order to prevent personal injury. 5. Hoist the tube end of boom cylinder (1). By using a bar and hammer, pull out pin (6) to the position where the cylinder rod can be removed. 3 4 5 6 NOTE: When pin (6) cannot be removed, start the engine and operate the boom lever in order to adjust the hole position of boom cylinder (1) piston rod end. IMPORTANT: The grease fitting is equipped for the tube in boom cylinder (1). Insert a plate in order not to touch the grease fitting. 6. Insert a plate between the boom cylinder and main frame. Hold and lower the boom cylinder. 7.

Remove the other boom cylinder in the same procedures as steps 5, 6. W166-04-01-005 W157-04-01-005 W4-1-2 Pl 1 ate