FRONT ATTACHMENT / Front Attachment 8. Start the engine. Operate the boom lever and retract the rod of boom cylinder (1). In order not to extend the rod, pass a wire through the rod hole and secure the rod to the cylinder tube. Stop the engine. 9. Operate the control lever several times with the pilot shut-off lever in the UNLOCK position and release any pressure in the circuit. NOTE: The accumulator is equipped for the pilot circuit. After the engine stops and when the control lever is operated with the pilot shut-off lever in the UNLOCK position, any pressure can be released in the front attachment circuit. 10.
Release any pressure in the front attachment pipe and bleed air in the hydraulic oil tank. (Refer to W4-1-1, W1-4-1.) NOTE: Steps 10 to 12 are for the machine attached with the auto lubrication device (optional). 11. Remove lubrication hose (7). Cap the removed hoses. : 19 mm 12. Remove bolt (8) and remove clip (9). : 17 mm 13. Remove the clip bands (10) (2 used). 14. Remove socket bolts (12) (16 used). Remove hoses (11) (4 used). Cap the removed hoses. 7 8 : 12 mm 15. Remove bolts (13) (2 used) from plate (14) in boom foot pin (15). 9 12 10 : 30 mm M1J1-07-049 11 11 13 15 14 W105-04-01-007 W4-1-3