hitachi — MAINTENANCE STANDARD

FRONT ATTACHMENT / Cylinder MAINTENANCE STANDARD Cylinder Tube 1. Tube Section (1) Check the inside and outside for any damage. 1 2 2. Pin, Bushing Section (2) Check whether the wear on surface of inner diameter is 0.5 mm (0.02 in) more than specified dimension (B). Check the inside for any damage. IMPORTANT: Check the inner bore in tube completely. Cylinder Rod 1. Rod Section (3) Place two V-blocks 1 m apart on level ground. Lay the cylinder rod across the V-blocks. Rotate the rod one turn and measure the rod deflection by using a dial gauge. Measure the deflection in three positions. If one measured deflection is 1 mm or more, replace the rod. Check the surface for any damage.

Check the plated part for any rust. Check the cushion part for any damage. 2. Pin, Bushing Section (4) Check if the bushing bore (D) wear is 0.2 mm or more than specification. Check the inside for any damage. B A W145-04-01-015 4 3 Piston C D W166-04-02-023 Dial Gauge Cylinder Rod W166-04-02-022 1 m Standard Dimension List Unit: mm (1 mm=0.03937 in) V Block W4-2-28 Boom Arm Bucket Cylinder Tube Inner Dia. (A) 170+0.063 0 190+0.072 0 110+0.063 0 Cylinder Tube Pin, Bushing Bore Dia. (B) 110+0.25 +0.05 110+0.25 +0.05 100+0.25 +0.05 Rod Dia. (C) Recommended O.D size after Re-plating 115-0.012 -0.027 130+0.031 -0.061 120+0.027 -0.057 Piston Rod Pin, Bushing Bore Dia.

(D) 120+0.25 +0.05 110+0.25 +0.05 110+0.25 +0.05 Adjusted Piston Rod Deflection 0.125/1000