1.2 CYLINDER HEAD 5. Seal the turbocharger compressor inlet and discharge with covers or masking tape. Plug the oil supply fitting in the turbocharger housing. 6. Remove and inspect the exhaust manifold if necessary. Refer to section 7.2.2 and refer to section 7.2.2.1. See Figure 1-28. 1. Exhaust Manifold 2. Heat Shield Figure 1-28 Exhaust Manifold (Series 60G Engine) (Rev. 2005) All information subject to change without notice. 1-38 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION