Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

3.1 OVERVIEW OF LUBRICATING SYSTEM Two holes in the bull gear recess area of the cylinder block are drilled into the cylinder block front-cross oil gallery, and supply oil to the bull gear bearings, bull gear and camshaft idler gear and hub. See Figure 3-2. Figure 3-2 Gear Train Oil Supply Holes Excess oil from the bull gear lubricates the crankshaft timing gear and oil pump drive gear. A hole at the top, front of the block, drilled into the block front-cross oil gallery, mates with an oil passage in the gear case that directs oil to the adjustable idler gear assembly. See Figure 3-2. Excess oil from the adjustable idler gear lubricates the accessory drive and water pump drive gears.

The bearings and shafts of these two drive assemblies are splash-fed oil through holes in their housings. On engines equipped with an air compressor, a flexible, external oil line runs from a threaded hole at the top, front corner of the left side of the cylinder block, which is tapped into the main oil gallery. The flexible line runs to a fitting at the air compressor assembly. Oil drains from the air compressor through a hole in the air compressor drive housing into the gear case. NOTE: On early Series 60 engines equipped with an air compressor, there was a "T" fitting in the air compressor drive assembly.

A flexible external oil line ran from the cylinder block to this "T" fitting and another line ran from the "T" fitting to the air compressor assembly. (Rev. 2005) All information subject to change without notice. 3-6 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION