Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

3.2 OIL PUMP 3.2.2 Removal of Oil Pump Remove the oil pump as follows: 1. Remove the drain plug from the oil pan and drain the oil. Refer to section 14.6.1. 2. Remove the oil pan bolts, isolators, sleeves and washers, and oil pan. Refer to section 3.11.2. NOTICE: The thru-bolts must be loosened first to prevent twisting the oil pick-up tube. Failure to do this could cause eventual stress-crack damage at the pick-up tube to flange joints. 3. Loosen but do not remove the thru-bolts securing the oil pump bracket to the pick-up tube. 4. Remove the two bolts that secure the oil pump pick-up tube support bracket to the cylinder block. 5.

Remove the two bolts securing the oil pump pick-up tube to the oil pump. 6. Tap the pick-up tube gently to loosen it from the gasket and remove the pipe. 7. Remove the two bolts securing the outlet pipe to the pump and cylinder block. 8. Tap the outlet pipe gently to loosen it from the gaskets and remove the pipe. NOTICE: If removing the oil pump from the vehicle, loosen the bolts; but leave them in place to prevent the pump from falling, before the mechanic removes the oil pump. 9. Remove the four bolts retaining the oil pump to the cylinder block. 10. If necessary, pry gently on the oil pump assembly to loosen it from the block. NOTE:

Remove and save the shims, if used, between the oil pump mounting feet and the cylinder block. The shims are used to adjust the oil pump drive gear-to-crankshaft timing gear lash. (Rev. 2005) All information subject to change without notice. 3-12 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION