3.4 OIL PRESSURE RELIEF VALVE 3.4 OIL PRESSURE RELIEF VALVE Oil leaving the pump under pressure passes into the pressure relief valve body. The spring-loaded valve opens when the pressure exceeds 724 kPa (105 psi) and directs the excess oil to the oil pan. The pressure relief valve is attached to the oil pump outlet tube (on 1991 and later engines), or the oil pump body (on pre-1991 engines). See Figure 3-11. The pressure relief valve consists of a valve body, a hollow, piston-type valve, a spring, spring seat and a pin to retain the valve assembly within the valve body. The relief valve assembly is composed of the same parts as the regulator valve assembly with the exception of the body.
See Figure 3-12. The valve is held on its seat by the spring, which is compressed by the pin in back of the spring seat. The entire assembly is bolted to the lower flange of the cylinder block and sealed against leaks by a gasket between the block and valve body. When conditions are such that the oil pressure at the valve exceeds 689 kPa (100 psi), the valve begins to be forced from its seat and oil from the engine gallery is bypassed to the engine oil pan. Thus, stable lubricating oil pressure is maintained at all times. (Rev. 2005) All information subject to change without notice. 3-28 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION