Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL Assemble the relief valve as follows: 1. Apply clean engine oil to the outer face of the valve. 2. Slide valve into the oil pressure regulator body, closed end first. See Figure 3-16. 3. Insert the spring in the valve and install the spring seat. NOTICE: The retaining pin must be positioned correctly so the proper valve opening pressure will be obtained. Although the same casting is used for both the pressure regulator and relief valves, the regulator valve has a slightly larger opening machined into the side. See Figure 3-16. 4. While compressing the spring, install the retaining pin behind the spring seat. 5.

Press the pin flush to 0.254 mm (0.010 in.) below the surface of the valve body. 3.4.6 Installation of Oil Pressure Relief Valve Install the oil pressure relief valve as follows: 1. Remove all traces of old gasket material from the mating surfaces of the oil pressure relief valve body and the cylinder block. 2. Place a new gasket onto the relief valve body. 3. Secure the oil pressure relief valve assembly to the cylinder block with two bolts. Torque the bolts to 30-38 N·m (22-28 lb·ft). 4. Refer to section 12.3 for verification of proper oil pressure relief valve installation. All information subject to change without notice. (Rev.

2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 3-33